| BASIC BOW GPS/FISHFINDER |
$110.00 |
| BASIC CONSOLE GPS/FISHFINDER |
$220.00 |
| STRUCTURESCAN®** |
$220.00 |
| TROLLING MOTOR (TM) |
ESTIMATE |
| TM-PRE-WIRED OR REPLACEMENT |
$220.00 |
| STEREO & SPEAKERS INSTALLATION |
ESTIMATE |
| BIMINI TOP INSTALL |
STARTING AT $220.00 |
| SHALLOW WATER ANCHOR |
STARTING AT $220.00 |
| ELECTRIC ANCHORMATE® |
ESTIMATE |
| AERATOR PUMP REPLACEMENT |
STARTING AT $110.00 |
| BILGE PUMP REPLACEMENT |
STARTING AT $110.00 |
| NEW KEEL PROTECTOR INSTALL |
$220.00 |
| GUIDE-ON TRAILER BUNKS (2) |
$110.00 |
| BATTERY CHARGER |
STARTING AT $110.00 |
| 12V ACCESSORY PLUG |
$110.00 |
| FUEL/WATER SEPARATOR |
$110.00 |
| ATV/UTV ACCESSORIES INSTALL |
ESTIMATE |
| ANNUAL SERVICE - 2.5-30HP OUTBOARD |
$165.00 |
| ANNUAL SERVICE - 40-115HP OUTBOARD |
$220.00 |
| ANNUAL SERVICE - 150-300HP OUTBOARD |
$275.00 |
| ANNUAL SERVICE - 350HP OUTBOARD |
$330.00 |
| ANNUAL SERVICE - STERNDRIVE |
$275.00 |
| OUTBOARD IMPELLER |
STARTING AT $165.00 |
| STERNDRIVE IMPELLER |
STARTING AT $220.00 |
| REPACK TRAILER BEARINGS PER AXLE W/BRAKES |
$220.00 |
| REPACK TRAILER BEARINGS PER AXLE |
$165.00 |
| TRAILER LIGHT REPLACEMENT |
STARTING AT $27.50 |
| DIAGNOSTIC SERVICE |
STARTING AT $110.00 |
| PROP RECONDITIONING |
ESTIMATE |
| 34-POINT INSPECTION*** |
$55.00 |
| ATV/UTV OIL CHANGE |
$55.00 |
| FULL ATV/UTV SERVICE |
STARTING AT $165.00 |
| ATV/UTV CV JOINT BOOT R&R |
$165.00 |
| SHOP RATE |
$110.00/HR |
* DOES NOT INCLUDE PARTS & SHOP SUPPLIES
** ADDITIONAL COST FOR NETWORKING
*** FREE W/PAID SERVICE |
- Replace spark plugs
- Replace impeller
- Lubricate all points
- Adjust carburetor
- Check engine timing
- Drain & replace gear lube
- Lubricate prop shaft
- Check trim fluid
- Check control cables
|
- Remove engine deposits
- Check Ignition system
- Replace H2O separator
- Inspect fuel filter element (EFI models)
- Replace fuel filter (EFI models)
- Grease bearings
- Inspect Belt
|
|
- Replace spark plugs
- Change engine oil & filter
- Replace impeller
- Drive belt inspection
- Replenish all fluids
- Lubricate propeller
- Replace sterndrive
- Gear lube
- Inspect ignition
- Grease bearings
|
- Retourque gimbal ring
- Lubricate gimbal bearings
- Check cables & linkage
- Inspect drive unit bellows
- Adjust carburetor, if necessary
- Adjust timing, if necessary
|
|
